BMB KSP-100 Owner's Manual download pdf (Page 4)

Power Supply

• Do not connect this unit to same electrical

outlet that is being used by an electrical

appliance that is controlled by an

inverter or a motor (such as a refrigerator,

washing machine, microwave oven, or air

conditioner). Depending on the way in which

the electrical appliance is used, power supply

noise may cause this unit to malfunction

or may produce audible noise. If it is not

practical to use a separate electrical outlet,

connect a power supply noise lter between

this unit and the electrical outlet.

• The AC adaptor will begin to generate heat

after long hours of consecutive use. This is

normal, and is not a cause for concern.

• To prevent malfunction and equipment

failure, always make sure to turn o the

power on all your equipment before you

make any connections.

Placement

• Using the unit near power ampliers (or

other equipment containing large power

transformers) may induce hum. To alleviate

the problem, change the orientation of this

unit; or move it farther away from the source

of interference.

• This device may interfere with radio and

television reception. Do not use this device

in the vicinity of such receivers.

• Noise may be produced if wireless

communications devices, such as cell

phones, are operated in the vicinity of this

unit. Such noise could occur when receiving

or initiating a call, or while conversing.

Should you experience such problems, you

should relocate such wireless devices so they

are at a greater distance from this unit, or

switch them o.

• Do not expose the unit to direct sunlight,

place it near devices that radiate heat, leave

it inside an enclosed vehicle, or otherwise

subject it to temperature extremes. Excessive

heat can deform or discolor the unit.

• When moved from one location to another

where the temperature and/or humidity is

very dierent, water droplets (condensation)

may form inside the unit. Damage or

malfunction may result if you attempt to use

the unit in this condition. Therefore, before

using the unit, you must allow it to stand for

several hours, until the condensation has

completely evaporated.

• Depending on the material and temperature

of the surface on which you place the unit, its

rubber feet may discolor or mar the surface.

You can place a piece of felt or cloth

under the rubber feet to prevent this from

happening. If you do so, please make

sure that the unit will not slip or move

accidentally.

• Do not put anything that contains water on

this unit. Also, avoid the use of insecticides,

perfumes, alcohol, nail polish, spray cans,

etc., near the unit. Swiftly wipe away any

liquid that spills on the unit using a dry, soft

cloth.

Maintenance

• For everyday cleaning wipe the unit with a

soft, dry cloth or one that has been slightly

dampened with water. To remove stubborn

dirt, use a cloth impregnated with a mild,

non-abrasive detergent. Afterwards, be sure

to wipe the unit thoroughly with a soft, dry

cloth.

• Never use benzine, thinners, alcohol or

solvents of any kind, to avoid the possibility

of discoloration and/or deformation.

Additional Precautions

• Please be aware that the contents of memory

can be irretrievably lost as a result of a

malfunction, or the improper operation of

the unit.

• Unfortunately, it may be impossible to

restore the contents of data that was stored

in the unit’s memory once it has been lost.

BMB International Corp. assumes no liability

concerning such loss of data.

• Use a reasonable amount of care when using

the unit’s buttons, sliders, or other controls;

and when using its jacks and connectors.

Rough handling can lead to malfunctions.

• Never strike or apply strong pressure to the

display.

• When disconnecting all cables, grasp the

connector itself—never pull on the cable.

This way you will avoid causing shorts, or

damage to the cable’s internal elements.

• When you need to transport the unit,

package it in the box (including padding)

that it came in, if possible. Otherwise, you

will need to use equivalent packaging

materials.

• Some connection cables contain resistors.

Do not use cables that incorporate resistors

for connecting to this unit. The use of such

cables can cause the sound level to be

extremely low, or impossible to hear. For

information on cable specications, contact

the manufacturer of the cable.

• Depending on the circumstances of a

particular setup, you may experience a

discomforting sensation, or perceive that the

surface feels gritty to the touch when you

touch this device, microphones connected to

it, or the metal portions of other objects. This

is due to an innitesimal electrical charge,

which is absolutely harmless. However,

if you are concerned about this, connect

the ground terminal (see gure) with an

external ground. When the unit is grounded,

a slight hum may occur, depending on the

particulars of your installation.

Unsuitable places for connection

• Water pipes (may result in shock or

electrocution)

• Gas pipes (may result in re or explosion)

• Telephone-line ground or lightning

rod (may be dangerous in the event of

lightning)

Copyrights / Licenses / Trademarks

• It is forbidden by law to make an audio

recording, video recording, copy or

revision of a third party’s copyrighted work

(musical work, video work, broadcast, live

performance, or other work), whether

in whole or in part, and distribute, sell,

lease, perform, or broadcast it without the

permission of the copyright owner.

• Do not use this product for purposes that

could infringe on a copyright held by a

third party. We assume no responsibility

whatsoever with regard to any infringements

of third-party copyrights arising through

your use of this product.

• MMP (Moore Microprocessor Portfolio)

refers to a patent portfolio concerned with

microprocessor architecture, which was

developed by Technology Properties Limited

(TPL). Roland has licensed this technology

from the TPL Group.

• This product contains eCROS integrated

software platform of eSOL Co.,Ltd. eCROS is a

trademark of eSOL Co., Ltd. in Japan.

• Roland and V-Remastering are either

registered trademarks or trademarks of

Roland Corporation in the United States and/

or other countries.

• Company names and product names

appearing in this document are registered

trademarks or trademarks of their respective

owners.

IMPORTANT NOTES

1 2 3 4 5 6 7 8 9 ... 21 22

Comments to this Manuals

No comments

BMB KSP-100 Owner's Manual Page 4

Comments to this Manuals

Related products and manuals for Karaoke systems BMB KSP-100